Anedio A1 Manual do Utilizador descarregar pdf (Página 13)

12 Anedio A1 Power Amplifier

Trouble Shooting

Symptoms Remedy

No power

• Ensure the power cord is plugged in fully.

• Check the fuse. If blown, ensure that the

outputs are not shorted. Replace it only

with 2A/250V 5x20mm time-lag

(slow-blo). Using an incorrect fuse will

void the warranty.

Power on but no

sound

• Ensure that the source component is turned

on.

• Ensure that the interconnects and cables

are plugged in fully and seated properly.

LED indicator

changed to purple

• Immediately turn off the power.

• Ensure that the output terminals and the

loudspeaker terminals are not shorted.

• (In the passive bi-amp mode only) ensure

that the high and low frequency drivers of

the loudspeakers are not shorted together.

• Once the short-circuit condition is cleared,

wait about 1 minute and turn on power.

Hum

• Ensure that all components are connected

to a single power strip.

• If there is a cable TV or antenna connection,

ensure that the cable/antenna grounds are

galvanically isolated from the audio ground.

This may require inserting a ground

isolator.

Diffused stereo

imaging

• Ensure that the loudspeaker phase is not

inverted.

Mono sound

• For “normal” (stereo) mode, ensure that the

passive bi-amp switch is set to “normal.” If

it is unintentionally set to “biamp,” the

resulting sound will be mono.

If the problem persists, please contact Anedio via the Contact page

at www.anedio.com.

WARNING: Repairs are to be performed by qualified service

personnel only. To reduce the risk of electric shock, do not perform

any servicing other than that contained in the operating

instructions.

1 2 ... 8 9 10 11 12 13 14

Comentários a estes Manuais

Sem comentários

Anedio A1 Manual do Utilizador Página 13

Comentários a estes Manuais